Speaking loudly puts strain on your voice and can do permanent damage if you’re not careful. Since you are using amplification, you shouldn’t need to shout into the microphone.Even if you hit the resonant frequency dead-on, you’ll have to hold the pitch perfectly for a few seconds before the glass vibrates enough to shatter. Sustain your note as long as possible while making slight adjustments.The vowel “ay” is also rated very highly for volume. In particular, the "ee" vowel sound has the highest volume rating. Vowels are less obstructed and will help you to achieve louder volumes.The pitch you are singing might only be off a slight bit, but this can prevent your glass from breaking. If your glass refuses to break, check your pitch with a pitch finder.Then increase your volume until you are singing into the microphone directly at a moderate volume. Slide your voice in very small increments around the resonant pitch until you feel confident that you have it perfectly. You’ll want to save your voice from unnecessary strain by singing at a soft to moderate volume. More likely you’ll have to “slide” your voice slightly up and down and make slight adjustments to match the resonant pitch. Vowel sounds will be less obstructed, enabling you to achieve higher volumes.Hold off singing until your voice is back to normal. To prevent permanent damage, you should stop immediately, drink some water. If you feel discomfort, pain, or notice a significant change in the quality of your voice, you may be straining your voice by singing too loudly or too long.When you are confident that you are singing the pitch perfectly, slowly increase your singing volume into you are singing as loudly as you can. Does it sound sharp (above the resonant pitch) or flat (below the resonant pitch)? If so, make slight adjustments to your tone. Listen carefully to the sound of your voice. Begin singing the resonant tone at a normal speaking volume. Things that are inside, on top of, or connected to your glass could alter this tone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |