![]() That’s especially necessary if you plan to take lengthy hydroplane rides. Inspect the area fullyīefore hydroplaning, you would like to ensure that the water in front of you covers an area of at least 20 to 30 feet, with a consistent level. Because no joke, falling a few times is inevitable during the learning process. It would also be great if you could take a few falls. ![]() So before trying, make sure you are fit to run, jump, and maintain your balance on the skim board. Skimboarding is a physically demanding activity that requires sound physical health. Keeping that into account, the following are some of the most basic precautions you would like to take before you go on throwing your board into the waters: Make sure you’re physically fit Hydroplaning, or skimboarding in general, is a very challenging and physically dangerous sport for novices not familiar with the technicalities of the activity. Some precautions before you go hydroplaning This will keep your speed consistent, and give you the much-needed stability when you’re hydroplaning on deeper water, or meet a wave, let’s say. Step 4: Rotate itĪs soon as you get on the skimboard, the next thing you do is rotate the skimboard in such a way that your frontal side is facing the direction you are moving in. You’re surely going to fall at least once until you’re an ace skimmer. It will make the board shoot off in the forward direction, and you will ultimately end up hurting yourself.įor extra safety, we would highly recommend wearing a helmet in the first few tries. However, there are some technicalities you must keep in mind to ace the technique.Īlways run alongside the board with an even speed and aim to take at least 3 steps before getting your feet on the board.Īlso, never push off too hard with your first foot. Remember, you don’t “jump” on the board you simply step on it in a gliding motion, with your front slightly past the center and the back foot a few inches from the tail. We would also highly recommend throwing the board a few times from the starting position to warm up or simply to get the feel of the water. Once the board catches speed, it can then safely hydroplane on water deeper than an inch. You’re good to go if the water in front of you has a height between the specified measurements. The optimum water level for hydroplaning lies between 0.25 and 0.5 inches in the initial stages (when throwing the board). Step 2: Throw it where the water level is optimum ![]() This significantly reduces the initial velocity of the board, and as soon as it touches the water surface, it is faced with high resistance.Īs a result, the board doesn’t cover much distance, and you won’t be able to ride much farther once the board enters a slightly deep water zone. ![]() One of the most common beginner’s mistakes is keeping the front of the board upward while throwing. When holding the board, ensure its direction is parallel to the water. To perform it correctly, you will need everything tip-top, from the type of board you use to your overall technique.Īlso read: Do you need waves to skimboard? (hint: not always) So, how do you hydroplane on a skimboard?Īssuming that you have mastered the basics of skimboarding already, let’s get straight into how to hydroplane on a skimboard like a pro: Step 1: Position yourself properlyįirst, lean forward and hold your hydroplane board roughly 6 inches above the water, with one hand on the tail and the other on the side rail midway along with the hydroplane board. Hydroplaning is relatively advanced compared to other tricks you can do with a skim board. Once the skimboard stops, the user must pick it up and repeat the process, which involves re-orienting the skimboard and throwing it in the water again in the desired direction. This is done by building up speed, throwing your skim board forward, getting on it, and then rotating it in a way that your front side faces the direction you are moving in. Hydroplaning is when you ride on top of the water instead of cutting through it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |